What does a handyman from SD Assembly Pros do in San Diego?
A handyman from SD Assembly Pros installs, repairs and mounts the small things in a San Diego home that do not need a remodel crew. That covers doors and locks, drywall patches, grab bars and hand rails, garage storage, pet doors, cabinet and drawer repair, light fixtures, ceiling fans, caulking, weather stripping and baby-proofing.
If you searched for a handyman near me, the practical question is whether your list fits one visit. Owner Stephan Lawrence runs SD Assembly Pros under California contractor licence CSLB #833940, and you can look that number up on the Contractors State License Board website before you book. The same San Diego technicians who carry out Wayfair Home Assembly and HandyBuddy orders take handyman bookings direct through this page.
Which handyman jobs can be booked in one visit?
Most handyman jobs on the SD Assembly Pros list are short enough to combine, so one visit can cover several rooms. Group the tasks by type when you send them, because a door that will not latch, a wall patch and a grab bar each call for different tools, fasteners and drying time.
Doors, locks and weather stripping
A replacement lockset has to match the hole already bored in the door and its backset, which is the distance from the door edge to the centre of that hole. Measure both, or send a photo with a tape measure in it, before you buy a deadbolt.
- Interior and exterior door installation
- Knob, lever and deadbolt replacement
- Hinge repair and sticking-door adjustment
- Weather stripping and door sweeps
Drywall patching
Small holes are filled and sanded. Larger openings, such as the gap left by a removed fixture, get a backed patch, tape and joint compound in coats, so allow drying time before paint. Send a photo with something for scale and say whether the wall is smooth or textured.
- Nail pops, dents and anchor holes
- Cut-out patches for larger damage
- Cracks along seams and corners
Grab bars and hand rails
A grab bar only works if it is fixed to framing or to an anchor rated for the load. Height and position are set to suit the person who will use the bar, and the manufacturer\'s instructions give the load rating and the fasteners to use.
- Shower, tub and toilet-side grab bars
- Hallway and stairway hand rails
Garage storage and safes
Overhead racks and loaded shelving hang from ceiling joists and wall studs, not from drywall. Safes are bolted to the slab or the framing through the holes the manufacturer provides, so have the installation sheet and the model number to hand.
- Wall shelving, pegboard and tool organizers
- Overhead ceiling storage racks
- Bike and sports equipment racks
- Safe installation and anchoring
Pet doors, windows and exterior installs
A pet door is cut to the template that ships with it, so the brand and size decide whether it can go in your door or wall. Exterior penetrations in stucco, the usual San Diego siding, are sealed after the fixture goes on.
- Pet doors in wood and metal doors, and wall-mount units
- Window caulking, weather sealing and film
- Mailboxes, house numbers and exterior fixtures
- Holiday light hanging and removal
Cabinets, drawers and baby-proofing
Drawer slides and concealed hinges are sold by length and overlay. A photo of the old part with a tape measure beside it is usually enough to source the match. Baby-proofing covers cabinet locks, safety gates and anti-tip straps for dressers and bookcases.
- Drawer slide and hinge replacement
- Cabinet door realignment and pull-out organizers
- Child safety locks, gates and furniture anchors
Light fixtures and ceiling fans
Fixture and fan swaps use the wiring and the ceiling box that are already in place. A ceiling fan must hang from a box listed for fan support. If the existing box is a plain light-fixture box, say so in your request so the job is quoted correctly.
Mirrors, art, floating shelves and curtain rods are booked under wall hanging and mounting for mirrors, shelves and gallery walls.
Do you need a handyman, a carpenter or a specialty contractor?
A handyman is the right call when the job is a repair or installation that uses the framing, wiring and plumbing already in the house. A carpenter builds or reshapes wood on site. A specialty contractor is required where California regulates the trade, for example new electrical circuits, gas lines or roofing.
| Who | Typical tasks | When you need them |
|---|---|---|
| Handyman | Hang a door, replace a deadbolt, patch drywall, mount grab bars, swap a light fixture on an existing box, put up garage shelving | Several small jobs, no new structure, no new circuits or pipe runs |
| Carpenter | Custom shelving, built-ins, deck repair, fence installation, framing, trim | Wood has to be measured, cut and fitted to the house |
| Licensed specialty contractor | New circuits and panel work, gas lines, repipes, sewer work, re-roofing | The work needs a trade classification and usually a permit |
The middle row is covered on the page about hiring a carpenter in San Diego County. EV chargers show where the third row starts: on an EV charger installation, SD Assembly Pros handles charger placement, wall mounting, site evaluation and permit coordination, and the regulated wiring, circuit, panel and final connection work is completed by a licensed electrical contractor.
If you are comparing quotes from individuals who work without a contractor licence, the guide to California handyman job limits and the under-$1,000 exemption explains what they may legally take on.
What should you have ready before a handyman visit?
Before a handyman visit, SD Assembly Pros needs the task list, the brand names or model numbers of anything being installed, and a photo of each spot. The booking form on this page asks for those details with a preferred date and time window, and they decide which anchors and tools the job needs.
- Send the list Name each task in the booking form. Add the brand and model number of anything new, such as a lockset, fan, pet door or safe.
- Pick a date and window Choose a preferred date and a time window. Visits run Mon–Fri 8AM–5PM and Sat–Sun 10AM–2PM.
- Read the quote SD Assembly Pros replies with a quote and available times. The quote reflects the number of tasks, the wall or door material and access.
- Clear the work area Move furniture away from walls being patched, empty the cabinet being repaired and unbox any fixture you bought yourself.
- Pay by card Visa, Mastercard and Discover are accepted.
What is outside the scope of the handyman service?
The handyman service from SD Assembly Pros stops where a job needs new wiring, new gas or drain lines, structural changes or roof work. Those jobs belong with a contractor who holds the matching trade classification, and most need a permit from the building division of your city or the county.
- New electrical circuits, panel changes and final EV charger connections.
- Gas lines, repipes and sewer work. Faucets, toilets and disposals are covered under fixture-level plumbing services.
- Removing or opening up a load-bearing wall.
- Roof repairs and anything that needs engineered drawings.
Handyman work is one of the services SD Assembly Pros provides in San Diego County. The full list of assembly, mounting and repair services shows what else can go on the same request.
Handyman Services FAQ
SD Assembly Pros prices a handyman visit from the details you send, so there is no flat figure to quote here. The number of tasks, the wall or door material, the height of the work and how easy the area is to reach all change the price. Send the list and photos to get a quote.
Yes, where the wiring and the ceiling box are already there. SD Assembly Pros swaps light fixtures and ceiling fans on existing boxes. A ceiling fan needs a box that is listed for fan support, so say what is there now. New circuits, new switch runs and panel work go to an electrical contractor.
Yes. A grab bar on tile is fixed through the tile into the wood studs or blocking behind it, or with a hollow-wall anchor that the bar manufacturer rates for the load. In a private home the height is set to suit the person using the bar, so have that person there when positions are marked.
The SD Assembly Pros handyman service covers 26 San Diego County communities, from Oceanside, Carlsbad and Vista in the north to Chula Vista, National City and Imperial Beach in the South Bay, and east to El Cajon, Santee, Alpine and Ramona. Each community has its own page under Service Areas.
Handyman visits run Monday to Friday from 8AM to 5PM and Saturday and Sunday from 10AM to 2PM. The booking form asks for a preferred date and a time window inside those hours. SD Assembly Pros accepts Visa, Mastercard and Discover.